Prospective owner of a Reliq, here! Hello 🙂
I’ve been poring over the manual and I haven’t worked out whether or not the matrix/mix parameters themselves can be directly controlled by aspects of the sequencer, in particular, the LFO.
If, for example, I desired for the Reliq to apply a panning effect to two consecutive outputs (running a stereo signal), I would reasonably set up two identical LFOs in phase with each other to modify the respective attenuation levels of the two outputs. But: the manual doesn’t seem to indicate that this is an option, unless one were to apply a MIDI loopback routing; sending CC commands that the Reliq would itself receive and then respond to.
Am I incorrect in this or am I missing something?
Thank you for your attention!!! Very excited at the possibilities this device is inspiring.